We recommend that you do not apply the Flipbac on top of a LCD protector.
We will not warrant adhesion if a LCD protector is used with the Flipbac. Please
remember that the Flipbac will provide good protection for your camera's LCD.
Many people find they do not need a LCD protector when using the Flipbac.
Basically, yes, you can remove it without damaging your LCD. However, the current Flipbac was not designed to be taken off and put back on. We use a semi permanent 3M adhesive. It will not damage your camera if you remove the Flipbac. If the camera surface was clean you may even be able to re-apply the Flipbac. We offer replacement 3M stickers upon request.
To remove the Flipbac just slowly and evenly (try not to bend the frame) pull the mirror/frame away from the camera and the adhesive will release. If there is any adhesive remaining on the camera (and there shouldn't be) it will roll off like rubber cement. We thoroughly tested several adhesives and found the 3M gave us no problems/damage whatsoever. How to remove
Again, the Flipbac is designed to stay mounted to your camera. Actually, we find having the Flipbac on the camera allows for more spontaneous use of this feature. If you need it, it is there to use and you don't lose the moment as you are trying to re-attach the Flipbac. Since it opens to more than 180-degrees horizontally and vertically, the mirror can easily and quickly be flipped out of the way for those times you don't want to use it. It really does become part of the camera and using the Flipbac becomes very intuitive.
Using the Flipbac for over heads shots is easy. Mount it as recommended but just turn the camera upside down to use the Flipbac while taking overhead photos. It may take a moment to get used to having the camera buttons on the bottom, but unless the majority of your photos are taken from the overhead position, this shouldn't be a big issue. How to use.